Bobcat Drive Belt Tensioner Adjustment. Bobcat 863 bf4m1011f engine. Need to know procedures on how to replace There may be a decal on the tailgate with directions and picture but if notLoosen the bolt that holds the tensioner just enough to allow the tensioner to move with a prybar, pry the tensioner down with a bar until the pointer on the tensioner is at the 3:00 position, then tighten the bolt while. The pointer was not budging, so I took the tensioner all the way off.
Bobcat 853 Drive Belt tensioner replacement Part 1 YouTube from www.youtube.com
I changed out all the belts on my 773 and noticed that the main drive belt tensioner was not really moving the belt as I tried to tighten it as per the repair manual and the sticker on the inside of the rear door. surely you can design a patented Bobcat idler adjusting tool and make a mint! willie59 Administrator
Bobcat 853 Drive Belt tensioner replacement Part 1 YouTube
surely you can design a patented Bobcat idler adjusting tool and make a mint! willie59 Administrator To adjust the drive belt between the flywheel and the hydrostatic pump pulley, use the following procedure: Stop the engine The pulley tensioner is located between the flywheel and pump pulley.
Bobcat Drive Belt Adjustment. Loosen and remove the bolt (Item 1) [Figure 30-60-7] from the belt tensioner Remove the drive belt from the loader [Figure 30-60-8]
Drive Belt Tensioner Pulley 6735884 Bobcat. I changed out all the belts on my 773 and noticed that the main drive belt tensioner was not really moving the belt as I tried to tighten it as per the repair manual and the sticker on the inside of the rear door. The pulley tensioner is located between the flywheel and pump pulley.